Individual Dies & Accessories
Custom Bullet Seating Stems
These seating stems are designed to fit Hornady® Custom Grade™ Dies and are machined to fit the profile of the A-MAX, A-Tip®, ELD Match, ELD-X, FTX and MonoFlex bullets to seat them as precisely as possible without damaging bullets. (Not compatible with other manufacturers’ dies.)
A-MAX®
A-Tip® Match
ELD® Match
CX™
ELD-X®
FTX™
MonoFlex®
Die Storage Boxes
Item #544600Every Hornady® Custom Grade™ and Match Grade™ die set comes in a convenient box that’s compartmentalized for dies, bushings, shell holders and a taper crimp die.
Stackable and clearly labeled, they offer an organized and clean approach to storing your dies, and can be purchased separately.
MicroJust™ Seating Stem
Item #044090Add the MicroJust™ to a Custom Grade Hornady® seating die, and you can precisely set bullet seating depth in .001” increments. It’s aquick and easy way to achieve benchrest accuracy and consistency without the extra cost of another seating die. Hornady® die sets already include an in-line seater; simply replace the standard seating adjustment stem with the MicroJust™ seating stem.
Universal Decapping Die
Item #050085Universal decapping die to decap military cases that have swaged primer pockets and are hard on conventional sizing/decapping dies.
Universal Decapping Pins
Taper Crimp Dies
This die removes the flare from the case mouth and crimps the case mouth around the bullet while maintaining a sharp edge for proper headspace.
Improves feeding of reloaded cases in semiautomatic handguns.
Sure-Loc™ Lock Rings
Item #044000Allows you to make precise adjustments of all standard 7/8"-14 dies and accessories. Clamps around the whole die and won’t damage the threads. Applies constant pressure across the threads to hold the ring in place.
Wrench Flats: Remove and replace dies without pliers ruining the lock ring.
6 Pack Item #044606
Lock-N-Load® Deluxe Die Wrench
Item #396495The Deluxe Die Wrench holds the shell plate and keeps it from rotating while you change plates and tighten the main press screw. It also adjusts the tightness of the spindle lock and the lock rings, and can tighten or loosen the die flats.
Hornady® Die Wrench
Item #396490Fits the flats of the Custom Grade™ dies spindle assembly, lock rings and die body.
Stuck Case Remover
Item #050033Easily remove stuck cases from dies by drilling and tapping the stuck case. Consists of #7 drill and 1/4 inch-20 tap.
Blank Ammunition Die Set
Item #544591For loading blanks this set produces a star crimp for all popular cartridges from 223 through 45-70. Compatible with 7/8" x 14 TPI presses.